QMOBILE I5I 2019 SC7731E FRP LOCK
Her is complete videos and pictorial guide on how to remove QMOBILE I5I 2019 SC7731E FRP LOCK
Step 1
Connect Your infinity box dongle with PC
Step 2 Open CM2SP2 v2.04 or whichever you have
Step 3 Under CPU [Platform] Select SC7731E_BASE and SC7731E_eMMC_1GB_RS under Model[Type] as shown in image below
Step 4 Go to Service Tab and select Default [Reset Settings + FRP] and click on Fomat FS Button as shown in image.
Step 5 Remove Battery from your phone and insert it back, Insert boot cable and connect with PC without holding boot keys.
Operation : Format FS / Reset Settings [ v2.04 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device …
Device Connected!
ERROR : Protocol HandShake failed!
Error : Fail to init protocol!
Remove battery, cable. Check cable and connection. Repeat operation!
Reconnect Power/Cable!
Operation : Format FS / Reset Settings [ v2.04 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device …
Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731E_BASE : SC7731E_eMMC_1GB_RS
Sending Init Boot …
Boot sent!
Kick FDL …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : Control transfered!
Boot Done!
Wipe Ok : UserData
Wipe Ok : Cache
Wipe Ok : FRP
Reconnect Power/Cable!
Done!
Elapsed: 00:02:56
It was all about qmobile i5i 2019 SC7731E FRP Lock remove procedure.
Share this post if it helped you.
Leave a Reply